Honda Pioneer Forums banner
1 - 6 of 6 Posts
G

·
Discussion Starter · #1 ·
My exhaust servo motor is out again (second one). Is there a way to bypass the exhaust valve so I can continue to ride untill my new servo motor arrives?
 
G

·
Discussion Starter · #2 ·
Yes, physically turn the servo to the fully open position and unplug it. Then get yourself a full micron exhaust system and pcIII. And never worry about it again.
 
G

·
Discussion Starter · #3 ·
Thanks for the reply. Already have a pcIII. I did see a eliminator kit made by Hass Motorsports that would be cheaper than a full system.
 
G

·
Discussion Starter · #5 ·
turn the valve so that it locks when its at the top of its travel however it will turn again its self with vibration restricting your air flow so make a little bracket to lock it in place
 
G

·
Discussion Starter · #6 ·
can just take the flapper out of the exhaust all together and throw a bolt in there to cover up the hole, load a proper map.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top