Honda Pioneer Forums banner
1 - 3 of 3 Posts
G

·
Discussion Starter · #1 ·
I have a 04 GSXR 600 and I just took the stock rear blinkers out and installed an hotbodies undertail that comes with led blinkers. my right rear blinker works fine but my left rear blinker stays on all the time and does not blink. Could anyone help please. also am I going to burn the leds if I try reversing the wires.
Thanks
 
G

·
Discussion Starter · #2 ·
You can install resistors on the line. I had the same problem on my 954 when I installed an LED undertail. I placed resistors on both sides and everything was fine. The resistors also slow down the blink rate of the signal. So instead of a real fast blink the signal will blink as normal stock.
 
G

·
Discussion Starter · #3 ·
Thanks for the reply, My problem was actually stupidity. I had installed the wire from license plate instead of the blinker and that was why it stayed on instead of blinking.
Thanks again
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top