Honda Pioneer Forums banner
1 - 7 of 7 Posts
G

·
Discussion Starter · #1 ·
Ok, a friend of mine did his own service last night on his 2005 1000RR and he rang me half way through it in tears.... its a feckin nightmare to get the plugs out, went to his house to give him a hand and eventually got them out... Now.. I usually do my own servicing, but.. feck.. I'm having second thoughts now..

Any advice!!!
 
G

·
Discussion Starter · #3 ·
the first time is the worst! i have found after a couple of times its alot easier......plus I'm an x-mechanic with a large assortment of tools so that helps too..but the more you tear it down the easier it usualy comes.
 
G

·
Discussion Starter · #6 ·
The one thing I made peace with is to phone and call a friend.
Nothing beats the two heads team. Not even obscure instructions and fade out scematics.
We are so close now that we work on each others projects.:cool:

But then again, this is how the frienship was launched, right into troubled waters. :thumb:
 
G

·
Discussion Starter · #7 ·
You wouldn't believe the room and ease of service you get after removing every non-essential component off the bike. I knocked off at least 10 pounds off my bike.

Without 4 pounds worth of heavy plastic flapper assembly, I can just reach right up there with a wrench and check the plugs. Yes, that cruft weighs that much. Lots of room and nothing to remove. Couldn't be easier. There's also a bunch of plastic sheets covering the engine surface that I guess that are supposed to insulate heat and noise. Out they went too. I can reach just about everything with my fairings on.
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top