Honda Pioneer Forums banner
1 - 5 of 5 Posts
G

·
Discussion Starter · #2 ·
you just need the socket?? you can get them at lowes, hardware store etc, then just drive the axle out.

i think its 21mm could be wrong though, just hold the other side w/ channel locks or use a large wrench i think i used 1 1/8 not sure what it is metric
 
G

·
Discussion Starter · #5 ·
so if i cut the end of a 24mm socket like the castle pattern it will work/fit?

I have access to a machine shop to do it.

Otherwise you gotta buy one from the Honda dealer.
 
1 - 5 of 5 Posts
Top